VINYL DECALS
Customized vinyl decals for your business
Custom-cut decals, lettering, and more made with 3M adhesive vinyl. Send us your logo and artwork or our designers can create it for you from scratch.
What we offer
Have Your Design Standard or Reverse Cut
You can choose eitherStandard or Reverse Cut for your vinyl lettering. Standard Cut makes it so each letter and object in your design will be cut directly out of the vinyl material, leaving no background. With Reverse Cut, each element in your design will be cut away from the background of the vinyl material.
Standard Cut
(Design Cut from Material)
Reverse Cut
(Design Cut Out of Material)
-
2″ Vinyl Decal – Round
$27.00 – $218.00 -
3″ Vinyl Decal – Round
$61.00 – $492.00 -
5″ Vinyl Decal – Round
$245.00 – $1,963.00 -
3″ x 4″ Vinyl Decal – Rectangle
$82.00 – $654.00 -
4″ x 4″ Vinyl Decal – Square
$109.00 – $873.00 -
3″ x 5″ Vinyl Decal – Rectangle
$123.00 – $981.00 -
4″ x 6″ Vinyl Decal – Rectangle
$164.00 – $1,308.00 -
4″ Vinyl Decal – Round
$109.00 – $873.00
How to Install Vinyl Lettering
Follow the step by step instructions below to help you get it installed exactly as you want it.
Thoroughly clean and dry the surface where the lettering will be installed.
After measuring and marking your intended installation location if necessary, apply a horizontal strip of masking or painters tape to the top of the graphic with the top half on the intended surface, creating a hinge.
Hold the bottom edge of the hinged graphic away from the intended surface and remove the back liner (which is different from the transfer tape), revealing the sticky backing of your lettering or graphic. Be careful not to allow the exposed adhesive to touch the surface.
Using a squeegee, apply pressure to the front or pre masked side of your lettering, placing the graphic onto the intended surface. Squeegee from left to right from the top down. If creases or bubbles develop, carefully lift the graphic and re-squeegee it.
Once in place without creases or bubbles, squeegee the entire lettering or graphic to ensure the adhesive is firmly attached to the surface.
Gently remove the pre-mask transfer tape, starting at a top corner. If any vinyl begins to come off the wall, use your squeegee to firmly adhere it back to the wall and continue peeling away the premask.
Laying the liner over the graphic with the shiny side facing you, apply hard pressure with the squeegee, removing any stubborn air bubbles.